Westermo MR Series - Manual (Page 167)

167 6622-3201
Web Interface and Command Line Reference Guide www.westermo.com
Async Mux 0710 Parameters
Note
The parameters listed under this heading are intended for use in providing technical support
only and should not be adjusted in normal operation.
Using Text Commands
From the command line, use the lapbcommand to configure or display LAPB settings. To display cur-
rent settings for a LAPB instance enter the command:
lapb ?
where is 0 or 1. To change the value of a parameter use the command in the format:
lapb
The parameters and values are:
Parameter Values Equivalent Web Parameter
ans off, on Answering
cli number CLI
dtemode 0,1 DTE/DCE mode: 0=DTE 1=DCE
keepact off, on Keep Activated
l1iface isdn, port Layer 1 interface
l1nb 0,1 Sync port
msn number MSN
n400 1-255 N400 counter
ptime number Passive timer (ms)
restartact 0,1 Restart when activate: 0=No 1=Yes
sub number Sub-address filter
t1time number T1 timer (ms)
t200 number T200 timer (ms)
tinact number Inactivity timer (s)
tinactx25 number Inactivity timer when X25 (s)
tnoact number Activity timer (ms)
window 1-7 Window size
For example, to enable answering on LAPB 0 you would enter the command:
lapb 0 ans on