Westermo MR Series - Manual (Page 149)

149 6622-3201
Web Interface and Command Line Reference Guide www.westermo.com
discover whether or not one or both ends of a tunnel is behind a NAT box, and implements a
standard NAT traversal protocol if NAT is being performed.
The version of NAT traversal supported is described in the IETF draft “draft-ietf-ipsec-nat-t-
ike-03.txt”.
NAT traversal keep-alive interval (s)
This parameter may be used to set a timer (in seconds), such that the unit will send regular
pack ets to a NAT device in order to prevent the NAT table from expiring.
RSA private key file:
This parameter specifies the name of a file for the X.509 certificate holding the unit’s private
part of the public/private key pair used in certificate exchanges. See “X.509 Certificates” in the
“IPSec and VPNs” section for further explanation.
Re-key time (s):
When the time left until expiry for this SA reaches the value specified by this parameter, the
IKEv2 SA will be renegotiated i.e. a new IKEv2 SA is negotiated and the old SA is removed. Any
IPSec “child” SAs that were created are retained and become “children” of the new SA.
Using Text Commands
From the command line, use the ike2 command to configure or display IKEv2 Responder settings. To
display current settings for the IKEv2 responder enter the command:
ike2 ?
where is 0.
To change the value of a parameter use the command in the format:
ike2 0
The parameters and values are:
Parameter Values Equivalent Web Parameter
inactto 0-255 Inactivity timeout
ltime 1-28800 Duration
natkaint number NAT traversal keep-alive interval (s)
natt off, on NAT traversal enabled
noresp off, on Act as initiator only
privrsakey filename RSA private key file
rauthalgs md5, sha1 Acceptable authentication algo-
rithms
rdhmingroup 1,2,5 Minimum acceptable MODP group
rekeyltime number Re-key time (s)
rencalgs des, 3des Acceptable encryption algorithms
renckeybits 128, 192, 256 Acceptable encryption key length
(AES only)
rmdhaxgroup 1,2,5 Maximum acceptable MODP group
rprfalgs md5, sha1 Acceptable PRF algorithms
Note:
Using ! for a parameter in a text command means blank.
For example, to set the Acceptable authentication algorithms to “MD5” only you would enter:
ike2 0 rauthalgs md5