Westermo MR Series - Manual (Page 381)

381 6622-3201
Web Interface and Command Line Reference Guide www.westermo.com
CLR Clear an X.25 Call 11.4.3
The CLR command is used to clear the current call and release the associated virtual channel
for fur ther calls. On completion of call clear the PAD> prompt is re-displayed. A call may also be
cleared as a result of a number of other situations. If one of these situations occurs, a message is
issued to the PAD in the following format:
CLR C: -
where:
is a 2/3 character clear down code
is the numeric equivalent of the clear down code
is a description of the reason for clear down
The clear down reason codes supported by the unit are listed in the following table:
Reason Code Numeric Code Text
DTE 0 by remote device
OOC 1 number busy
INV 3 invalid facility requested
NC 5 temporary network problem
DER 9 number out of order
NA 11 access to this number is barred
NP 13 number not assigned
RPE 17 remote procedure error
ERR 19 local procedure error
ROO 21 cannot be routed as requested
RNA 25 reverse charging not allowed
ID 33 incompatible destination
FNA 41 fast select not allowed
SA 57 ship cannot be contacted
If an unknown reason code is received, the text field is blank.
ICLR Invitation To CLR 11.4.4
The ICLR command “invites” the remote X.25 service to CLR the current X.25 session.
INT Send Interrupt Packet 11.4.5
INT causes PAD to transmit an interrupt packet. These packets flow “outside” normal buffering/flow
control constraints and are used to interrupt the current activity.
LOG Logoff and Disconnect 11.4.6
LOG is used to terminate an X.25 session. It causes the PAD to clear any active X.25 calls, discon-
nect and return to AT command mode.
PAR? List Local X.3 Parameters 11.4.7
PAR? lists the local X.3 parameters for the current session.