Westermo MR Series - Manual (Page 190)

190 6622-3201
Web Interface and Command Line Reference Guide www.westermo.com
Using Text Commands
From the command line, use the PPP command to set or display PPP parameter settings. To display
current settings for a PPP instance enter the following command:
ppp ?
where is the number of the PPP instance.
To set the value for a parameter enter the command in the format:
ppp
The parameters and values are:
Parameter Values Equivalent Web Parameter
ans off, on Answering
aodi_dly number AODI delay (s)
aodi_dly2 number AODI delay when other PPPs inhibited by this one
are connected
aodinua number AODI NUA
autoassert 0,1,2 Always on mode: 0=Off 1=On 2=On Imm. Return
cdma_backoff off, on None. Causes PPP backoff of fail ure. 1 min>2
min>8 min>15 min.
cingnb number Calling number
cli number CLI
deflate 0,1 DEFLATE compression: 0=Off 1=On
detach off, on Detach GPRS between connection attempts
detach_on_fail off, on Detach GPRS on link failure
DNSserver IP address DNS server
do_nat 0,1,2 NAT mode: 0=Off 1=NAT 2=NAPT
epassword text None - this is the password in encrypted format.
This parameter is not configurable.
firewall off, on Firewall
gre off, on GRE
igmp off, on IGMP
immoos off, on Go out of service if first AODI con nections fail
IPaddr IP address Local IP address
ipanon off, on IP analysis
IPmin IP address Remote IP address pool minimum
IPrange number Remote IP address pool range
ipsec 0,1,2 IPSec: 0=Off 1=Remove SAs 2=Keep SAs
mask IP netmask Remote network mask
maxneg number Maximum negotiation time (s)
maxup number Maximum link up-time (s)
maxuptime number Max up-time per day (mins)
minup number Minimum link up-time (s)
mppe off, on MPPE encryption
mppebits 0,40,56,128 MPPE key size: 0=Auto
msn number MSN
multi off, on Multi-link
name text Name
natip IP address NAT source IP address
netip IP address Remote network IP address