Using text commands – Westermo MR Series User Manual
Page 287
287
6622-3201
Web Interface and Command Line Reference Guide
www.westermo.com
Using Text Commands
From the command line use the user command to configure settings for the authorised users. To
display current settings for a particular user enter the command:
user
where
This lists the username, password, the encrypted form of the password and the user access level.
To change the value of a parameter use the command in the format:
user
The parameters and values are:
Parameter
Values
Equivalent Web Parameter
access
0-4
User access code: 0=Super 1=High 2=Medium 3=Low 4=None
dun_en
off, on
DUN access enabled: off=No on=Yes
ipaddr
IP address
IP address
keyfile
filename
Public Key file
mask
IP netmask
IP mask
name
text
Username (up to 14 characters)
newpwd
text
New Password (up to 14 characters)
password
text
Password (up to 14 characters)
phonenum
number
Dialback number
webmode
0, 1, 2
Web page display mode: 0=Auto 1=Basic 2=Advanced
For example, to set the username for User 2 to “James” enter the command:
user 2 name James