Westermo MR Series - Manual (Page 176)

176 6622-3201
Web Interface and Command Line Reference Guide www.westermo.com
Debug level:
This parameter is used to control the amount of information contained in debug traces. It can
be set to “Off”, “Low”, “Med” or “High”. Setting the parameter to “Off” disables debug tracing.
Using Text Commands
From the command line, use the ospf command to configure or display the OSPF settings. To display
current settings for OSPF enter the following command:
ospf ?
where is 0.
To change the value of a parameter use the following command:
ospf
The parameters and values are:
Parameter Values Equivalent Web Parameter
adj_to 1-2147483647 Adjacency timeout (s)
adv_only off, on Advertise routes only
conffile text Configuration file
debug 0,1,2,3 Debug level: 0=Off 1=Low 2=Med
3=High
def_hello_int 1-65535 Default ’Hello’ interval (s)
def_metric 1-65535 Default metric
def_prio 0-255 Default priority
def_retran_int 5-3600 Default retransmit interval (s)
def_rtr_dead_time 2-2147483647 Default router dead time (s)
def_spf_delay 1-10 Default SPF delay (s)
def_spf_hold 1-5 Default SPF hold time (s)
def_tx_delay 1-3600 Default transmit delay (s)
enable off, on Enable OSPF
fatal_rest off, on Restart OSPF after fatal error
id IP address ID
ignore_mtu off, on Ignore MTU indications
nbr_to 1-2147483647 Neighbour timeout (s)
new_cfg_rest off, on Restart OSPF when new config file
loaded
useipsecent off, on Use Interface IPsec source IP
For example, to set the Default SPF delay to 5 seconds enter:
ospf 0 def_spf_delay 5