Westermo MR Series - Manual (Page 305)

305 6622-3201
Web Interface and Command Line Reference Guide www.westermo.com
Using Text Commands
From the command line, use the ipx25 command to configure IP to X.25 calls. To display the current
mappings enter the following command:
ipx25 ?
where is the table entry number, i.e. 0 - 255. To change the value of a parameter use the fol-
lowing command:
ipx25
The parameters and values are:
Parameter Values Equivalent Web Parameter
cnf_mode 0.,1 Confirm Mode: 0=Off 1=On
ip_port number IP Port
iphdr 0,1,2 IP length header: 0=Off 1=On
2=8583 Ascii 4 byte
nb_listens number # Ports
pid hex numbers PID
x25call NUA, NUI or X.25 macro name X25 Call
For example, to set up table row 1 from the example you would enter the following series of com-
mands:
ipx25 0 iphdr 0
ipx25 0 ip_port 2004
ipx25 0 nb_listens 3
ipx25 0 x25call jollyroger