KEYENCE Visual KV Series - Manual (Page 431)

Appedix C. Ladder Program List Visual KV Series only
Appendicies
Appendices
1-407
Total count 3-152
Comparison of absolute values 3-154
Multiplying the counter current value by DM value 3-156
Total count average 3-158
Fetch input data separately 3-160
Output of BCD 2-digit data 3-162
Separate input of 2-digit BCD 3-163
Judgement of matching data 3-165
Fetching four-digit data of BCD digital switch (inputs 0004 through 0011 3-168
for low-order 2 digits and 0100 through 0107 for high-order 2 digits) to
transfer them as counter setting value
Separate input of BCD 3-168
Error input count 3-170
UP/DOWN count 3-173
Total count 1 3-174
Total count 2 3-174
Output of error input No. in BCD 3-178
Display of 7-segment LED 3-178
Output of 4-digit BCD data 3-181
Output of 8-digit BCD data 3-182
Input of 4-digit BCD data 3-182
Interrupt with a signal converter 3-198
Interrupt with a high-speed counter 3-199
Measuring the ON time of high-speed pulses 3-200
Measuring the period in which a target passes between two points 3-201
Comparing encoder values 3-217
24-bit high-speed counter (single-phase input) 3-224
Ring counter: When using a 16-bit high-speed counter 3-226
Ring counter: When using a 24-bit high-speed counter 3-227
Program using a digital trimmer 3-229
Program for speed control 3-230
Program for basic operation of the frequency counter 3-232
Program for synchronous control 3-232
Cam switch 3-236
To output a clock pulse of 1 ms (1 kHz)-period from output relay 0500 3-242
To output a clock pulse of 1 ms (1 kHz)-period from output relay 0501 3-243
To output a clock pulse of 500 µs (2 kHz)-period and 200 µs-width 3-245
from output relay 0500
To output a clock pulse of 500 µs (2 kHz)-period and 200 µs-width from 3-247
output relay 0501
Direct clock pulse output: Stopping the pulse output at a specified pulse 3-249
count
Direct clock pulse output: Ramp-up/down control 3-251
Ladder example of ramp-up/down control 3-259
Ladder example of the jog operation 3-260
Ladder example of automatic operation (palletizing operation) 3-261
Ladder example of a return to the zero point 3-262
Ladder example of an automatic operation (continuous operation 3-263
with wait status)
Ladder example of a pulse motor application circuit 3-264
KVHKA Appendix.p65 08.3.11, 11:05 AM 407