KEYENCE Visual KV Series User Manual
Page 223
6.1 Using the Handheld Programmer
Chapter 6 Handheld Programmer
1-199
1
6
■ Connection between the KV and Handheld Programmer
■ Connector cable for handheld programmer
•
Do not leave the connector cable connected to the PLC for a long period of time
such as during normal operation. It can be left connected during programming,
trial operation, monitoring, or adjustments which only take a relatively short
amount of time.,
•
Avoid binding the KV-P3E(01) connection cable together with, or placing the KV-
P3E(01) connection cable near, high power lines or output load lines. Failure to
do so may cause an operation failure.
•
Do not apply excessive force to the KV-P3E(01) connection cable.
•
Use only the connector cable provided by KEYENCE to prevent malfunction of
the PLC.
•
The KV-P3E(01) connection cable cannot be extended.
Connection to KV
Operation mode at power ON
Not connected
RUN mode
Connected
KV is set to mode switch setting.
Connected after power ON
KV is switched to mode switch setting.
KVHKA Chap 06_1&2.p65
08.3.11, 11:16 AM
199