Rockwell Automation 2098-UWCPRG Ultraware Software User Manual - Manual (Page 272)

274 Rockwell Automation Publication 2098-UM001G-EN-P - February 2011
Chapter 5 Configuring the Kinetix 3 Drive
Understanding the Analog
Outputs Window The Properties window for Analog Outputs looks like this.
Use the Analog Outputs window to assign drive signals to analog outputs.
The Analog Outputs parameters window has these parameters.
The following commands can be executed on an online drive using the Analog
Outputs window.
Customize the Analog Outputs window for your Kinetix 3 drive by selecting one
or more of these commands:
• Click Show Status to display or hide the Status pane.
• Click Revert to return parameter settings to the values they held when you
opened this window.
Parameter Description
Analog Output 1
Signal Sets the drive signal assigned to the output. Click the down
arrow to the right of this input box to open the Channel Setup
dialog.
Scale The output scale in units per volt. It is dependent on the signal
selected.
Analog Output 2
Signal Sets the drive signal assigned to the output. Click the down
arrow to the right of this input box to open the Channel Setup
dialog.
Scale The output scale in units per volt. It is dependent on the signal
selected.
Command Description
Save Parameters Saves the current working values as power-up values in flash
memory for the selected On-Line drive and all of its children.