Rockwell Automation 2098-UWCPRG Ultraware Software User Manual - Manual (Page 221)

Rockwell Automation Publication 2098-UM001G-EN-P - February 2011 223
Configuring the Kinetix 3 Drive Chapter 5
A Properties window, such as the Drive Properties window displayed
below, appears for the selected drive branch.
3. To configure properties for the selected drive branch, use the features of
the Properties window as follows.
Section Description
Parameters Located in the upper left part of the Properties window. Enter
values in the parameter fields to configure the settings of the
selected drive branch.
Commands Located in the upper right part of the Properties window. Click
any command to issue that command. Select Show Commands,
below, to display command buttons. Not every drive branch has
associated commands.
Status Located beneath the Parameters and Commands sections.
These default fields display the online status of the selected
drive branch. Click Setup to open a window where you can
customize the status to be displayed. Status fields are read-only.
Select Show Status to display the status section.
Note: Status values for offline drives may not be meaningful.
Show Status Displays the status for the selected drive branch.
Show Commands Displays commands for the selected drive branch. Commands
can be executed only for online drives. This selection is
dimmed, if no commands are associated with the selected
drive branch.
Setup Opens the Monitor Setup window, where you can customize the
status display.
Refer to Understanding the Monitor Window on page 275 for
more information about using the Monitor window.