Rockwell Automation 2098-UWCPRG Ultraware Software User Manual - Manual (Page 232)

234 Rockwell Automation Publication 2098-UM001G-EN-P - February 2011
Chapter 5 Configuring the Kinetix 3 Drive
The following commands can be executed for a Kinetix 3 Drive window that is in
the On-Line Drives branch. These commands are explained in these sections.
Customize the window for your Kinetix 3 Drive branch by selecting one or more
of these commands:
• Click Show Status to display or hide the Status pane.
• Click Show Commands to display or hide the Commands pane.
• Click Setup button to open the Refer to Monitor Setup Window on
page 276 , where you can customize the status display for this window.
• Click Revert to return parameter settings to the values they held when you
opened this window.
Velocity Control Panel Window
The Properties window for the Velocity Control Panel looks like this.
Command Description
Velocity Control Panel Opens the Velocity Control Panel window.
Refer to Velocity Control Panel Window on page 234 for more
information about how to set a drive's velocity command and
monitor its motor velocity or current.
Reset Drive Resets, or reboots, the hardware and firmware for a drive.
Reset to Factory Setting Resets a drive's parameters by reinitializing them to factory
default settings. Stored faults and the Time in Service clock
remain unchanged
Save Parameters Saves the current working values as power-up values in the
flash memory for the selected online drive and all of its children.
Setup Wizard Provides a quick way to perform the minimal configuration
necessary for a new Kinetix 3 drive.
Refer to Using the Setup Wizard on page 236 for more
information about this wizard.