Rockwell Automation 2098-UWCPRG Ultraware Software User Manual - Manual (Page 188)

190 Rockwell Automation Publication 2098-UM001G-EN-P - February 2011
Chapter 4 Configuring the Ultra5000 Drive
The following commands can be executed for the Oscilloscope window of an
online drive.
Customize the Oscilloscope window for your Ultra5000 Drive by selecting one
or more of these commands:
• Click Show Properties to display or hide the Properties pane.
• Click Show Commands to display or hide the Commands pane.
• Click Save to save the oscilloscope data to a tab delimited file on your PC,
which can be read by spreadsheet or presentation software. Information
saved includes the Oscilloscope data points from one or more channels.
• Click Revert to return parameter settings to the values they held when you
opened this window.
Channel Setup Window
The collapsed Properties window for the Channel Setup looks like this
Use this window to:
• Assign a specific Input Signal to the selected Channel in the Oscilloscope
window for an Ultra5000 drive, or
• Assign no Input Signal to the selected channel in the Oscilloscope window
for an Ultra5000 drive.
Command Description
Arm Trigger Turns the oscilloscope trigger ON.
Run Continuous Runs the oscilloscope continuously, circumventing the trigger.
Stop Triggering Turns the oscilloscope trigger OFF.