Festo Электромотор MTR-DCI - Manual (Page 93)

4. Control panel (only type MTR-DCI-...-H2)
4-21
Festo P.BE-MTR-DCI-CO-EN en 1209a
4.5.5 [Settings] [Password edit]
In order to prevent unauthorized or unintentional overwriting
or modification of parameters in the device, access via the
control panel can be protected by a (local) password. No
password has been preset at the factory (presetting = 000).
• Keep the password for the MTR-DCI in a safe place,
e.g. with the internal documentation for your system.
If the active password in the MTR-DCI should be lost in spite
of care being taken:
the password can be deleted by entering a master password.
In this case please contact your Festo Service partner.
Activate password
Select the menu [Settings] [Password edit].
Enter a password with 3 figures (0...9). The current entry
position is marked with a question mark.
1. Use the arrow buttons to select a figure.
2. Confirm your entry with .
3. Set a figure for the next entry position “?”.
4. After entering the third figure, save the password with
SAVE .
After saving, access to all parameter functions and control
functions of the control panel is only possible with a pass-
word access blocked.
New Password:
[?xx] =
ESC
EDIT <--> OK