Festo Электромотор MTR-DCI - Manual (Page 125)

5. Commissioning
5-27
Festo P.BE-MTR-DCI-CO-EN en 1209a
5.3.1 Installing the FCT
Note
The PlugIn MTR-DCI supports as from version V2.0.0 the
following motor units:
– MTR-DCI-...-CO: Firmware version as from V1.00
• Check with later versions of the MTR-DCI to ascertain
whether an updated PlugIn is provided. If necessary
consult Festo.
Note
Administrator rights are required for installing the FCT.
The FCT is installed on your PC with an installation program.
The PlugIn MTR-DCI is installed on your PC together with the
installation program of the FCT.
1. Close all programs.
2. Place the Festo Configuration Tool CD in your CD ROM drive.
If Auto Run is activated on your system, the installation will
start automatically and you can omit steps 3 and 4.
3. Select [Run] in the Start menu.
4. Enter D:\setup (if necessary replace D by the letter of your
CD ROM drive).
5. Follow the instructions on the screen.