Bit rate (can bit rate) – Festo Электромотор MTR-DCI User Manual

Page 121

5. Commissioning

5-23

Festo P.BE-MTR-DCI-CO-EN en 1209a

Bit rate (CAN bit rate)

–

Possible bit rates:
1000 kBit/s (1 Mbit/s), 800 kBit/s, 500 kBit/s, 250 kBit/s,
125 kBit/s, 100 kBit/s, 50 kBit/s, 20 kBit/s.

–

Preset is an

invalid bit rate

(on the control panel, displayed as “???”)
This makes sure that a correct address is set during com-
missioning or exchange.

Note
All the stations on a fieldbus line must use the same bit
rate. Otherwise, no communication will be possible.

The set bit rate is effective only

after Power off/on!

Set the bit rate as follows:

1. Select [Settings] [CAN parameter] [CAN Baud rate]

(see also section 4.5).

2. With “Enter” the current bit rate is displayed.

3. Use the arrow keys to set the desired bit rate.

4. Accept the bit rate with OK “Enter”.

The set bit rate is saved against network failure.

} Settings

CAN parameter

CAN baud rate

1000 kBd

ESC ”Menu”

EDIT ”--”

OK ”Enter”