IAI America RCM-101-USB - Manual (Page 77)

5. Editing Position Data on CON Controllers and Older Models
65
(9) Position data input area: RCP, RCS, E-Con, RCP2 and ERC
Enter position data in this area.
It is normally possible to input four items of “Position,” “Speed,” “ACC” and “Comment,” however, it becomes
further possible to input items of “Push,” “Pos. band,” “MAX ACC,” “ABS INC” by switching to detailed
indication with the “Indication switching” button .
Fig. 5.28 Position Data Input Area (Normal Mode)
Fig. 5.29 Position Data Input Area (Detail Mode)
[1] No.: Shows position data No.
[2] Position: The desired move location from home in millimeters.
‚
Absolute Positioning: (Incremental:0) Moves the actuator to the desired location in
reference to the home location. Inputting negative
values is not possible.
‚
Relative Positioning: (Incremental:1) Moves the actuator to the desired position in
reference to the current position. Inputting negatives
values is possible. (during negative direction of the
display coordinate)
Caution: There are cases when the input value may be rounded off to the least common denominator
multiple of the controller. (when data is acquired from the controller).
[1] [2] [3] [4] [5] [6] [7] [8]