IAI America RCM-101-USB - Manual (Page 125)

9. Setup
113
9. Setup
9.1 Setting of application Window
Click Setting from the main menu, and then select Application.
Fig. 9.1 Setting of application Window
[1] Port
When is clicked, the serial port list to communicate with the controller is displayed.
Select port from the list. If there is not check mark in the box of “Show All”, the COM ports detected
automatically are shown. With check mark, all the COM ports are shown.
[2] Baud rate
When is clicked, the communication baud rate the serial port list is displayed. Select baud rate from
the list.
* The baud rate selected here is used only in the communication between this application and controller.
It does not affect the communication speed parameters of the controller.
[3] Last axis No.
When is clicked, the axis No. list is displayed. Select axis No. intended for connected axis check.
* Axes of numbers greater than the value selected here will not be checked for connection. Select an
appropriate axis number after checking the axis numbers of the connected axes.
[4] Unit of display at pulse-train mode
When is clicked, units of display [mm], [pulse] in pulse-train mode are displayed.
For pulse sequence input controller such as PCON-PL/PO, units such as the current position on the status
monitor window (Fig.8.1) can be changed.
[5] Simple Program Start Position (V8.03.00.00 or later)
When is clicked, it can be selected whether the simple program is to be started from the cursor
position or the top of the program.
[6] Way to Show Position Data (V8.03.00.00 or later)
When is clicked, the way to show the position data when the position data edit window is displayed
can be selected whether it should be shown with the simple display or normal display.