IAI America RCM-101-USB - Manual (Page 36)

1. Preparation Before Use
24
1.3.4 How to Change the IAI USB COM Port
The COM port set during the installation of the USB conversion adapter driver software can be changed by
following the procedure below:
[1] Click Start on the Windows taskbar, Settings, and then Control Panel to open the Control Panel.
Double-click System to open System Properties.
Click the Hardware tab in System.
Click Device Manager in Hardware.
Double-click Ports (COM & LPT) in Device Manager to expand the folder tree.
[2] Double-click IAI USB to UART Bridge Controller (COM?).
(Note) “COM?” indicates the current COM port before change.
Fig. 1.40 Device Manager Dialog Box
[3] The IAI USB to UART Bridge Controller (COM?) Properties dialog box appears.
Click Advanced... in the properties dialog box.
Fig. 1.41 Properties Dialog Box
IAI USB to UART Bridge
Controller (COM?)