IAI America RCM-101-USB - Manual (Page 15)

1. Preparation Before Use
3
1.3 Installing the Software
This software is run from the hard disk. This section explains how to install the software.
1.3.1 How to Install the PC Interface Software for RC
[1] Insert the CD-Rom containing this software into your CD-ROM drive.
[2] The installed data selection window (Fig. 1.1) will be displayed.
Select the version you wish to install from these choices: PC Interface Software for RC (ENG) and PC
Interface Software for RC (EUR). Then click the corresponding button to begin the installation. (Some
items are not indicated depending on the version.)
Fig. 1.1 Installed Data Selection Window
(The displayed window may vary depending on the version or other factor.)
* What to do when the Installed Data Selection window (Fig. 1.1) does not appear
If the Installed Data Selection window (Fig. 1.1) does not appear after inserting the CD-ROM, follow the
procedure below to display the Installed Data Selection window.
a. Use Explorer, etc., to display a list of folders and files in the CD-ROM.
The window should display the icons shown in Fig. 1.2.
Fig. 1.2 Icons
b. Double-click among the icons displayed. The Installed Data Selection window (Fig. 1.1) will
appear.