IAI America RCM-101-USB - Manual (Page 184)

12. Off Board T
uning Function on SCON-CA
Controller
172
[2] Select actuator model
Fig. 12.7 Select actuator model
Source Data Select for Select actuator
Select the source data for the model selection.
If choosing “New adjustment model”, select the model to tune from the models registered in the actuator
attribute data file.
If choosing “Adjustment record”, select the model to tune from the models registered in the adjustment
record data saved in the past.
(Note) “Adjustment record” is not available to select unless there is adjustment record data.
Select actuator Settings
Set the data type, model code, lead, stroke and actuator installed orientation for the model to be tuned.
(Note) The model code, lead or stroke not registered in the source data for select actuator cannot be set.
Adjustment Record Data File Select
Fig. 12.8 Adjustment Record Data File Select
By clicking on button, the adjustment record data file to be used can be changed.
The name of the adjustment record data file being used is shown on the right of the button and is
underlined.
(Note) Selecting the adjustment record data file is only available when Source Data Select for Select
actuator is set to “Adjustment record”.
(Note) The file initially selected when the Off board tuning window is open is “\[RC PC Software Save
Folder]\DB_OFFBRD\DatRcrdAdjsted_200V_AC.orcd”.
(Note) If there is no adjustment Record Data File, or failed to open the file, the display of the adjustment
record data file select changes to the following display.
Fig. 12.9 Adjustment Record Data File Select (File not selected)
Source Data Select for Select actuator Select actuator Settings
Adjustment Record Data Select Adjustment Record Data File Select