Avago Technologies LSI SAS 3041E-R - Manual (Page 85)

Command Line Options 4-7
Version 1.3 Copyright © 2001, 2002, 2007 by LSI Logic Corporation. All rights reserved.
4.3 Command Line Options
The LSIMPTNW.HAM driver has many tuning parameters, as listed
below. A default is listed for each option, as well as a list of valid entries.
Each option has a description of when to use it, the syntax used, and
any impact its use may have on the system.
If an option is specified but the assignment is not valid, the default value
is used.
The options described below are used by typing the specified characters
on the load command line for the NWPA driver. For example, the load
command line to specify the Width SCSI Option is:
load LSIMPTNW.HAM width=narrow
Note: No spaces are allowed in a single command line option, but
spaces are required between different command line
options.
4.3.1 Information Option: Using the Help Mode Option
•
Command line option: ? or h
•
Function: Display the options available in the driver.
•
Possible Impact: The driver will not load with ? or h specified.
Use this command line option to view a brief description of each driver
option, as well as valid entries for each option. If the ? or h option is
specified along with other options, the help screen is invoked, the other
options are ignored, and the driver is not loaded.
4.3.2 NetWare NWPA Driver Customizable Options
Each command may be preceded by a "/" or "-" for backwards
compatibility at the discretion of the user. The line options with multiple
names are simply aliases for the same command. The command line is
case insensitive, so you can mix upper and lower case.
4.3.2.1 Using the Elevator Threshold Option
•
Syntax: elev=[targetIDlist] or
elevator=[targetIDlist]