Avago Technologies LSI SAS 3041E-R - Manual (Page 197)

Performing Configuration Tasks 9-31
Copyright © 2001, 2002, 2007 by LSI Logic Corporation. All rights reserved.
Figure 9.18 Exit Screen
9.4 Performing Configuration Tasks
This section explains how to use the setup utility to perform the following
configuration tasks:
•
Section 9.4.1, “Creating an Integrated Striping Volume”
•
Section 9.4.2, “Creating an Integrated Mirroring Volume”
•
Section 9.4.3, “Creating a Second RAID Volume”
•
Section 9.4.4, “Viewing RAID Volume Properties”
•
Section 9.4.5, “Adding or Deleting a Hot Spare”
•
Section 9.4.6, “Synchronizing an Array”
•
Section 9.4.7, “Activating an Array”
•
Section 9.4.8, “Deleting an Array”
•
Section 9.4.9, “Locating a Disk Drive”
•
Section 9.4.10, “Selecting a Boot Disk”
9.4.1 Creating an Integrated Striping Volume
An Integrated Striping (IS) volume (also called RAID 0) breaks up data
into smaller segments, then stripes the segments across each drive in
the array. IS volumes do not provide any data redundancy (you cannot
LSI Logic MPT Setup Utility v6.xx.xx.xx
Are you sure you want to exit?
Cancel Exit
Save changes and reboot
Discard changes and reboot
Exit the Configuration Utility and Reboot
Esc=Exit Menu F1/Shift+1=Help