Avago Technologies LSI SAS 3041E-R - Manual (Page 114)

6-16 Integrated RAID Configuration Utility
Version 1.3 Copyright © 2001, 2002, 2007 by LSI Logic Corporation. All rights reserved.
2. For LSI1064/1064E and LSI1068/1068E controllers, CFGGEN does
not allow adding a hot spare disk of a type (SAS/SATA) that is
different from the disk types in any of the volumes.
Command Line –
cfggen hotspare [delete]
cfggen hotspare [delete]
Parameters –
•
– Number of the SCSI bus or SAS controller targeted
by this command.
•
– SCSI ID of the drive targeted by this command.
•
– The enclosure:bay value for the disk drive to use
for the new hot spare disk. These values can be obtained via the
output of the DISPLAY command.
•
[delete] – Optional delete action to specify that the hot spare drive
with needs to be deleted.
Program Return Value –
0x00 SUCCESS: Command completed successfully.
0x01 FAILURE: Bad command line arguments or operational failure.
0x02 ADAPTER_NOT_FOUND: Specified adapter cannot be found.
6.3.10 LIST Command
The LIST command displays a list of all controllers present in the system,
along with their corresponding controller #.
Command Line –
cfggen list
Parameters – None
Program Return Value –
0x00 SUCCESS: Command completed successfully.
0x01 FAILURE: Bad command line arguments or operational failure.
0x02 ADAPTER_NOT_FOUND: Specified adapter cannot be found.