Avago Technologies LSI SAS 3041E-R - Manual (Page 109)

CFGGEN Commands 6-11
Version 1.3 Copyright © 2001, 2002, 2007 by LSI Logic Corporation. All rights reserved.
Parameters –
•
– Number of the SCSI bus or SAS controller targeted
by this command.
•
[filename] – Optional valid filename to store output of command to a
file.
Program Return Value –
0x00 SUCCESS: Command completed successfully.
0x01 FAILURE: Bad command line arguments or operational failure.
0x02 ADAPTER_NOT_FOUND: Specified adapter cannot be found.
Sample Output –
The following example shows the output of the DISPLAY command for
an IM configuration on a SAS1068 controller.
Note: The format and content of the DISPLAY command output
varies, depending on the CFGGEN version being used.
Read configuration has been initiated for controller 0
------------------------------------------------------------
Controller information
------------------------------------------------------------
Controller type
: SAS1068
BIOS version : 6.xx.xx.00
Firmware version : 0.09.03.219
Channel description : 1 Serial Attached SCSI
Initiator ID : 63
Maximum physical devices : 62
Concurrent commands supported : 511
Slot : 6
Bus : 3
Device : 1
Function : 0
RAID Support : Yes
------------------------------------------------------------
IR Volume information
------------------------------------------------------------
IR volume 1
Volume ID
: 7
Status of volume : Okay (OKY)
RAID level : 1
Size (in MB) : 34332
Physical hard disks (Target ID) : 11 8