Avago Technologies LSI SAS 3041E-R - Manual (Page 52)

3-12 UNIX Operating System Device Drivers
Version 1.3 Copyright © 2001, 2002, 2007 by LSI Logic Corporation. All rights reserved.
Installing LSI Logic FusionMPT(tm)
Fibrechannel/SCSI drivers as
## Installing part 1 of 1.
/kernel/drv/itmpt
/kernel/drv/itmpt.conf
[ verifying class ]
## Executing postinstall script.
Following installation, please reboot the system to properly
configure and load the drivers.
Installation of was successful.
Note: Refer to the file Errata_0708.pdf for configuration
instructions regarding non-zero LUNs.
Note: When the itmpt driver initializes an LSI Ultra320 SCSI or
LSI SAS host adapter’s disk drives, it attaches under the
Sun
sd target driver. To alter the probing of target IDs and
probing for non-zero LUNs on devices attached to an LSI
host adapter, modify the
/kernel/drv/sd.conf file.
When the itmpt driver initializes an LSI Fibre Channel host
adapter’s disk drives, it attaches under the Sun ssd target
driver. To alter the probing of target IDs and probing for
non-zero LUNs on devices attached to an LSI Fibre
Channel adapter, modify the
/kernel/drv/ssd.conf file or
use the lsiprobe utility.
3.2.5 Network System Installation of the Solaris SPARC Driver
If you install an LSI host adapter that you will use to control a Solaris
SPARC system disk, you must install the Solaris operating system and
the Solaris SPARC driver using the network installation instructions in
this section. This section describes a complete installation of Solaris to
a client system that is using an LSI host adapter to control the system
disk. The method described in this section installs the LSI
itmpt driver
onto a network boot kit, making it available during the SPARC installation
process.
If the LSI FC host adapter is an additional storage adapter added to an
existing Solaris SPARC system, refer instead to
Section 3.2.4, “Installing
the Driver on an Existing Solaris SPARC System.”