Avago Technologies LSI SAS 3041E-R - Manual (Page 128)

7-8 SCSI BIOS and Setup Utility
Version 1.3 Copyright © 2001, 2002, 2007 by LSI Logic Corporation. All rights reserved.
Figure 7.3 Global Properties Menu
Table 7.4 describes the Global Properties menu fields.
LSI Logic MPT SCSI Setup Utility Version MPT -x.xx
Global Properties
Pause When Boot Alert Displayed [Yes]
Boot Information Display Mode [Verbose]
Negotiate with devices [Supported]
Video Mode [Color]
Support Interrupt [Hook interrupt, the Default
Disable Integrated RAID [No]
Table 7.4 Global Properties Field Description
Field Description
Pause When Boot Alert
Displayed Specifies whether the BIOS pauses for user acknowledgement after
displaying an alert message during boot. To continue after displaying an alert
message, specify No. To wait for the user to press a key after displaying a
message, specify Yes.
Boot Information Display
Mode Specifies how much adapter and device information the BIOS displays during
boot. The options are Terse (display a minimum amount of information) or
Verbose (display detailed information).
Negotiate with Devices Determines whether sync and wide negotiations with a device will occur. The
options are:
•
All: Negotiations always take place.
•
None: Negotiations do not take place.
•
Supported: Negotiations take place if the device will be supported as an
INT13 device (accessible via boot support).
Video Mode Specifies the video mode for the setup utility: either Color or Monochrome.
The monochrome setting enhances readability on a monochrome monitor.
Support Interrupt This option allows you to prevent a hook on INT40, if required. Possible
values are:
•
Hook interrupt (default)
•
Bypass interrupt hook
Disable Integrated RAID If Yes is selected, the firmware does not to do a bus scan searching for RAID
member devices. It also disables configuration of RAID arrays in the BIOS.
Press Enter when this option is selected to restore default settings for the
options listed on this menu.