Avago Technologies LSI SAS 3041E-R - Manual (Page 81)

Introduction and Driver Features 4-3
Version 1.3 Copyright © 2001, 2002, 2007 by LSI Logic Corporation. All rights reserved.
Follow these instructions to upgrade to SMP after NetWare has been
installed:
1. At the server prompt, type: load install
A menu appears.
2. Select Multiprocessor.
Another menu appears.
3. Select the default: MPS14
4. Follow the remaining prompts and then exit load install.
5. Shut down the server and reboot the system.
Note: Other third-party CDMs may also support these devices.
4.1.2 Supported LSI Devices
The LSIMPTNW.HAM supports the following devices and associated LSI
host adapters:
•
LSI53C1020, LSI53C1030 (SCSI chips)
•
LSIFC929X (Fibre Channel chips)
•
LSI20320, LSI21320, LSI22320 (host adapters)
•
LSI7202 (Fibre Channel host adapter)
4.1.3 Driver Description
The LSI MPT NWPA solution consists of the device driver
LSIMPTNW.HAM and the NetWare NWPA installation file
LSIMPTNW.DDI.
LSIMPTNW is an NWPA Host Adapter Module (HAM). In order to
support SCSI devices, you must load the HAM module in conjunction
with a SCSI Custom Device Module (CDM). Novell has developed
generic CDMs to support SCSI Hard Drives, SCSI CD-ROM devices,
SCSI tape devices, and SCSI changer devices. In addition, third party
vendors are developing CDMs to support their specific devices.