beautypg.com

4 delete command, Delete command – Avago Technologies LSI SAS 3041E-R User Manual

Page 107

background image

CFGGEN Commands

6-9

Version 1.3

Copyright © 2001, 2002, 2007 by LSI Logic Corporation. All rights reserved.

– Size of the RAID volume in megabytes, or MAX for the
maximum size available.

– SCSI ID of a hard disk drive to be included in the RAID
volume.

– The enclosure:bay value for the disk drive to be
included in the RAID volume. These values can be obtained from the
output of the DISPLAY command.

qsync – If this optional parameter is specified, a quick
synchronization of new volume will be performed. If the volume type
is IME or IS, a quick synchronization is always performed even if
qsync is not specified. A quick synchronization means that the first
32 Kbytes of the drives in the volume are cleared to 0.

noprompt – Suppresses display of warnings and prompts.

Program Return Value –

0x00

SUCCESS: Command completed successfully.

0x01

FAILURE: Bad command line arguments or operational failure.

0x02

ADAPTER_NOT_FOUND: Specified adapter cannot be found.

6.3.4

DELETE Command

The DELETE command deletes all IM, IME, and IS volumes and hot
spare drives. No other controller configuration parameters are changed.

Command Line –

cfggen delete [noprompt]

Parameters –

– Number of the SCSI bus or SAS controller targeted
by this command.

noprompt – Suppresses display of warnings and prompts.

Program Return Value –

0x00

SUCCESS: Command completed successfully.

0x01

FAILURE: Bad command line arguments or operational failure.

0x02

ADAPTER_NOT_FOUND: Specified adapter cannot be found.