beautypg.com

2 netware 5.1 and 6.0 driver installation, Netware 5.1 and 6.0 driver installation – Avago Technologies LSI SAS 3041E-R User Manual

Page 83

background image

Installing the NWPA NetWare Driver

4-5

Version 1.3

Copyright © 2001, 2002, 2007 by LSI Logic Corporation. All rights reserved.

The MPT BIOS version 5.xx is the minimum MPT BIOS required for
NetWare when not used with ASPIMPT.SYS.

Follow these steps to check the status of DOS drivers:

1.

Edit the

CONFIG.SYS

file.

2.

If any of the following lines appear, you may remove or delete them.
(LSI recommends commenting them out with the REM command in
case they are needed later.)

DEVICE=\CDROM.SYS /d:
DEVICE=\SYMDISK.SYS
DEVICE=\HIMEM.SYS
DEVICE=\EMM386.SYS

3.

If SCSI CD-ROM support is required, add the following:

DEVICE=\ASPIMPT.SYS
DEVICE=\SYMCD.SYS /d:

4.

Add the following line to the

AUTOEXEC.BAT

file:

DEVICE=\mscdex /d:

4.2.2

NetWare 5.1 and 6.0 Driver Installation

Follow these steps to install the NetWare 5.1/6.0 driver.

1.

Begin the file server installation according to the instructions in the file
server installation chapter in the Novell NetWare Installation Manual.

2.

When the NetWare installation procedure prompts you for a disk
driver, insert the LSI device driver diskette into drive A: or B:.

3.

Use the INS key to select an unlisted driver.

A dialog box appears.

4.

If the driver diskette is in the A: drive, press Enter to continue. If the
driver diskette is in the B: drive, press F3 (to specify the path to
search for the driver), enter the drive letter B: and press Enter.

The LSIMPTNW.HAM driver will appear as a selection.

Note:

If the INS key option does not appear during the
installation, choose Server Drivers to go to the Summary
page. Highlight Disk and CD-ROM Drivers (e.g., IDEATA).
Press Enter and load an additional driver. Then press the
INS key. The system defaults to the A: path. Highlight the