9 hotspare command, Hotspare command – Avago Technologies LSI SAS 3041E-R User Manual
Page 113

CFGGEN Commands
6-15
Version 1.3
Copyright © 2001, 2002, 2007 by LSI Logic Corporation. All rights reserved.
The FORMAT command does not complete and return to a shell prompt
until the format operation is complete. This may take a long time for a
large disk drive.
Command Line –
cfggen
cfggen
Parameters –
•
•
•
formatted. These values can be obtained from the output of the
DISPLAY command.
•
noprompt – Suppresses display of warnings and prompts.
Program Return Value –
0x00
SUCCESS: Command completed successfully.
0x01
FAILURE: Bad command line arguments or operational failure.
0x02
ADAPTER_NOT_FOUND: Specified adapter cannot be found.
6.3.9
HOTSPARE Command
The HOTSPARE command creates a hot spare disk drive, which is
added to hot spare pool 0. The number of disk drives in an IM, IME, or
IS volume, including the hot spare disk, cannot exceed six for
LSI53C1020/1030 controllers or eight for LSI1064/1064E and
LSI1068/1068E controllers. Only one hot spare disk can be created.
The capacity of the hot spare disk must be greater than or equal to the
capacity of the smallest disk in the logical drive. An easy way to verify
this is to use the DISPLAY command.
The following rules must be observed when creating hot spare disks:
1.
A hot spare disk cannot be created unless at least one IM or IME
volume is already created.
- LSI SAS 3041X-R LSI SAS 3080X-R LSI SAS 3081E-R LSI SAS 31601E LSI SAS 3442E-R FusionMPT_DevMgrUG.pdf LSI SAS 3442X-R LSI SAS 3800X LSI SAS 3801E LSI SAS 3801X LSI SAS 3041X-R (Channel) LSI SAS 3080X-R (Channel) LSI SAS 3081E-R (Channel) LSI SAS 3442E-R (Channel) LSI SAS 3442X-R (Channel) LSI SAS 3800X (Channel) LSI SAS 3801E (Channel) LSI SAS 3801X (Channel) LSI20160 LSI20160 (Channel) LSI20320 LSI20320-R LSI20320-R (Channel) LSI20320IE LSI20320IE (Channel) LSI21320-R LSI21320-R (Channel) LSI22320-R LSI22320-R (Channel) LSI22320SE LSI22320SE (Channel) LSIU320 LSIU320 (Channel) LSI53C1020