beautypg.com

1 common command line parameters, Common command line parameters – Avago Technologies LSI SAS 3041E-R User Manual

Page 102

background image

6-4

Integrated RAID Configuration Utility

Version 1.3

Copyright © 2001, 2002, 2007 by LSI Logic Corporation. All rights reserved.

CFGGEN is not case sensitive. You can type CFGGEN commands and
parameters in uppercase, lowercase, or a mixture of the two. The
following conventions are used in the command descriptions:

Text in italics must be entered exactly as shown on the command
line.

Text surrounded by <> must be replaced with a required parameter.

Text surrounded by [ ] may be replaced by an optional parameter.

Parameters surrounded by { } must be entered one or more times, as
is appropriate for the command being executed.

The command line definition characters <>, [ ], and { } must not be
entered on the command line.

6.3.1

Common Command Line Parameters

This section describes CFGGEN command line parameters that are
used with more than one command.


The unique controller number of a PCI function found in the system,
starting with controller # 0. For SCSI controllers, the controller # is
used to address a particular SCSI bus in the system. For example,

ENABLEIR

Section

6.3.7

x

x

FORMAT

Section

6.3.8

x

x

x

HOTSPARE

Section

6.3.9

x

x

x

x

LIST

Section

6.3.10

x

x

x

LOCATE

1

Section

6.3.11

x

x

LOGIR

1

Section

6.3.12

x

SETOFFLINE

Section

6.3.13

x

x

SETONLINE

Section

6.3.14

x

x

STATUS

Section

6.3.15

x

x

x

x

VSIME

Section

6.3.16

x

1. This SAS-specific command is not supported on LSI53C1020/1030 SCSI controllers.

Table 6.1

CFGGEN Commands (Cont.)

Command

Reference

Supported in these Operating Environments

DOS

Linux

EFI

WinPE