Avago Technologies LSI SAS 3041E-R - Manual (Page 100)

6-2 Integrated RAID Configuration Utility
Version 1.3 Copyright © 2001, 2002, 2007 by LSI Logic Corporation. All rights reserved.
•
LSI53C1020 and LSI53C1030 SCSI controllers (DOS, Linux, and
WinPE environments only)
•
SAS1064/1064E, SAS1068/1068E, and SAS1078 SAS controllers
(the SAS1078 controller is not currently supported in the EFI
environment).
The supported versions of CFGGEN are as follows:
DOS Version –
CFGGEN operates in any environment that is fully compatible with
MS-DOS 6.22 and has at least 2 MB of memory. The system BIOS must
support 32-bit BIOS services, including the PCI BIOS services. CFGGEN
uses these services to locate the controller and its interface registers.
CFGGEN must be able to directly access the controller chip’s interface
registers.
Note: You cannot run CFGGEN in a virtual DOS window from
within Windows.
EFI Version –
CFGGEN operates in any environment that is fully EFI compatible.
Currently, this includes only the SAS controllers listed above.
Linux Version –
CFGGEN is a statically linked Linux application. Static linking prevents
any library version compatibility problems that might stop CFGGEN from
working with a specific release or distribution of Linux. Version 3.02.04
or newer of the LSI
mptlinux driver must be installed on the system. The
required modules include mptbase.o , mptscsih.o and mptctl.o .
Caution: mptbase.o , mptscsih.o and mptctl.o must be loaded into
the Linux kernel before CFGGEN will function correctly.
They can be loaded using the Linux
modprobe command.
WinPE Version –
CFGGEN operates in Windows Pre-Installation Environment (WinPE)
and is statically compiled with the LSI MptLib Library (
MptLib.lib ). The
WinPE environment must have the appropriate LSI MPT Windows driver