Avago Technologies LSI SAS 3041E-R - Manual (Page 61)

SCO OpenServer 5 Device Driver Installation 3-21
Version 1.3 Copyright © 2001, 2002, 2007 by LSI Logic Corporation. All rights reserved.
3.4.4 Installing the Driver on an New OpenServer UNIX System
Note: LSI recommends that you complete the entire installation
procedure in one session. This may take an hour or more.
This procedure installs SCO UNIX onto a hard disk drive and builds a
new UNIX kernel that includes the
lsil driver. During installation you are
given the option of retaining current partitions on the root hard disk drive.
For example, you might have already created a DOS partition or a UNIX
partition on the hard disk drive. Refer to the SCO OpenServer Handbook
for more details on SCO UNIX installation.
To complete a new installation of SCO UNIX and the lsil driver, follow
these steps:
1. Insert the SCO UNIX installation diskette and reboot the system. For
SCO OpenServer 5, this diskette is labeled Boot Disk.
2. At the boot prompt, type link and press Enter.
3. At the next prompt, type lsil and press Enter. Do not remove the
diskette.
4. When the installation prompts for the diskette, insert either the
installation diskette or the
lsil BTLD diskette, and press Enter.
5. If you see the following system prompt for a routine number, enter
the routine number that precedes the prompt:
Please enter which routine (0-40) to replace'?' to list):
'a' to add "lsilinit" at the end [default],
'n' to do nothing, or
'q' to quit"
6. If you see this additional system prompt for another routine number,
enter the indicated routine number that precedes the prompt:
Please enter which routine (0-2) to replace '?' to list),
'a' to add "lsilpoll" at the end [default],
'n' to do nothing, or
'q' to quit"
7. Continue the installation according to the instructions in the SCO
UNIX documentation.
The SCO OpenServer 5 system automatically creates a file,
unix.safe , during installation. To access this UNIX kernel, type
unix.safe at the boot prompt.