Avago Technologies LSI SAS 3041E-R - Manual (Page 101)

CFGGEN Interface Description 6-3
Version 1.3 Copyright © 2001, 2002, 2007 by LSI Logic Corporation. All rights reserved.
(ScsiPort or Storport) installed and loaded in order to recognize and
communicate with the I/O controller.
The WinPE utility does not recognize an LSI53C1030 or LSI53C1020
controller, unless there is at least one device attached to the controller.
6.2 CFGGEN Interface Description
CFGGEN uses a command line interface. Commands are formatted as
follows:
cfggen
The program name, controller number, command, and parameters fields
must be separated by a space. The format of the parameters is
command specific, as described in
Section 6.3, “CFGGEN Commands.”
Information is passed between the user environment and CFGGEN via
the command line, the standard output and standard error interfaces, and
the program return value. You can redirect the output streams as
permitted by the operating environment. The program return value is
returned when the program exits. A value of 0 is returned if the command
is successful. Otherwise, a value of 1 is returned.
6.3 CFGGEN Commands
Table 6.1 lists the CFGGEN commands and indicates which commands
are supported under each operating environment.
Table 6.1 CFGGEN Commands
Command Reference
Supported in these Operating Environments
DOS Linux EFI WinPE
AUTO Section 6.3.2 x x x
CREATE Section 6.3.3 x x x x
DELETE Section 6.3.4 x x x x
DISABLEIR Section 6.3.5 x x
DISPLAY Section 6.3.6 x x x x