Avago Technologies LSI SAS 3041E-R - Manual (Page 64)

3-24 UNIX Operating System Device Drivers
Version 1.3 Copyright © 2001, 2002, 2007 by LSI Logic Corporation. All rights reserved.
d. From the next list, select the type of tape drive to install and
press Enter.
e. When you are prompted to configure the tape drive, type y and
press Enter.
f. When you are prompted for the name of the device driver, type
lsil and press Enter.
g. When you are prompted for the host adapter that supports the
tape drive, type the host adapter number and press Enter. (The
host adapter number appears on the screen during boot-up.)
If you are adding another LSI host adapter to the SCO UNIX
kernel, the system might prompt you to update the link-kit. If this
happens, type y and press Enter. If you entered the host adapter
number incorrectly, type n and press Enter. The system then
prompts for the host adapter identifier.
h. When you are prompted for the bus number of the tape drive,
press Enter to accept the default (zero).
i. When you are prompted for the target ID of the tape drive, type
the tape drive ID number and press Enter. (The target ID
number appears on the screen during boot-up.)
j. When you are prompted for the LUN of the tape drive, type 0
[zero] and press Enter.
k. When you are prompted to update the configuration file, type y
and press Enter. A list appears showing the special devices
created.
l. Press Enter. A list appears showing the links to the installed tape
drive.
m. When you are prompted for a boot string, type q and press Enter
to return to the Tape Drive Configuration Program menu.
n. Type q and press Enter to terminate the Tape Drive
Configuration Program menu.
o. When you are prompted to create a new kernel type y and
proceed to step
13 if this is the last device to add. Type n and
return to step 10 if you want to add more devices.
12. Add a CD-ROM drive to the configuration by following the sub-steps
below. (If you are not adding a CD-ROM drive to this system, skip to
step
13 .)