Avago Technologies LSI SAS 3041E-R - Manual (Page 108)

6-10 Integrated RAID Configuration Utility
Version 1.3 Copyright © 2001, 2002, 2007 by LSI Logic Corporation. All rights reserved.
6.3.5 DISABLEIR Command
The DISABLEIR command disables Integrated RAID functionality on an
LSI1064/1064E or LSI1068/1068E controller. This is done by setting the
MPI_IOUNITPAGE1_DISABLE_IR bit in the IO Unit 1 MPT Configuration
Page.
If there are any existing IM, IME, or IS volumes when this command is
run, CFGGEN notifies you via an output message, no action is taken,
and CFGGEN returns FAILURE. If Integrated RAID is already disabled
when this command is run, CFGGEN returns SUCCESS.
Command Line –
cfggen disableir
Parameters –
•
– Number of the SAS controller targeted by this
command.
Program Return Value –
0x00 SUCCESS: Command completed successfully.
0x01 FAILURE: Bad command line arguments or operational failure.
0x02 ADAPTER_NOT_FOUND: Specified adapter cannot be found.
6.3.6 DISPLAY Command
The DISPLAY command displays configuration information for the
supported LSI controllers. The information includes controller type,
firmware version, BIOS version (version executed), volume information,
and physical drive information. The sample output below shows an
example of the information that is output by this command.
Note: 1 Mbyte = 1,048,576 bytes. All sizes displayed in Mbytes
are rounded down to the nearest Mbyte.
Command Line –
cfggen display [filename]