Avago Technologies LSI SAS 3041E-R - Manual (Page 111)

CFGGEN Commands 6-13
Version 1.3 Copyright © 2001, 2002, 2007 by LSI Logic Corporation. All rights reserved.
Numslots : 7
StartSlot : 2
Start TargetID : 0
Start Bus : 0
Enclosure# : 2
Logical ID : 500508b3:00a0535c
Numslots : 11
StartSlot : 0
Start TargetID : 0
Start Bus : 0
------------------------------------------------------------
Logical drive status values are as follows:
•
Okay (OKY) – Volume is Active and drives are functioning properly.
User data is protected if the volume is IM or IME.
•
Degraded (DGD) – Volume is Active. User data is not fully protected
due to a configuration change or drive failure.
•
Rebuilding (RBLD) – Data resync or rebuild may be in progress.
•
Inactive , Okay (OKY) – Volume is inactive and drives are
functioning properly. User data is protected if the current RAID level
is RAID 1 (IM) or RAID 1E (IME).
•
Inactive , Degraded (DGD) – Volume is inactive and the user data is
not fully protected due to a configuration change or drive failure; a
data resync or rebuild may be in progress.
Physical device status values are as follows:
•
Online (ONL) – Drive is operational and is part of a logical drive.
•
Hot Spare (HSP) – Drive is a hot spare that is available for replacing
a failed drive in an array.
•
Ready (RDY) – Drive is ready for use as a normal disk drive; or it is
available to be assigned to a disk array or hot spare pool.
•
Available (AVL) – Drive may or may not be ready, and it is not
suitable for inclusion in an array or hot spare pool (i.e., it is not spun
up, its block size is incorrect, or its media is removable).
•
Failed (FLD) – Drive was part of a logical drive or was a hot spare
drive, and it failed. It has been taken offline.
•
Standby (SBY) – This status is used to tag all non-hard disk drive
devices.