Avago Technologies LSI SAS 3041E-R - Manual (Page 79)

Fusion-MPT Device Management User’s Guide 4-1
Version 1.3 Copyright © 2001, 2002, 2007 by LSI Logic Corporation. All rights reserved.
Chapter 4
NetWare Drivers
This chapter describes the features and use of the LSI Fusion-MPT
NetWare Peripheral Architecture (NWPA) device drivers for the Novell
NetWare 5.1 and Novell Netware 6.0 operating systems. This chapter
contains the following sections:
•
Section 4.1, “Introduction and Driver Features”
•
Section 4.2, “Installing the NWPA NetWare Driver”
•
Section 4.3, “Command Line Options”
•
Section 4.4, “Supported DOS Configurations and DOS Drivers”
4.1 Introduction and Driver Features
The LSI MPT NWPA driver for the Novell NetWare operating system
allows you to utilize LSI SCSI Fusion MPT controllers and processors.
The MPT SCSI BIOS (version 5.02 or higher) controls these controllers
or processors with NetWare. This driver, together with the designated LSI
controllers or processors and an appropriate Custom Device Module
(CDM), provides a SCSI solution within the NetWare environment.
A single driver is provided for the Novell NetWare versions 5.1 and 6.0
environments. This chapter explains how to install and use the LSI MPT
NWPA SCSI Host Adapter Module (HAM) driver for NetWare.
Note: Current Netware drivers can be downloaded from the LSI
web site at http://www.lsi.com/support. After you are
connected to this web site, go to the Download Center.
Select the product category, then the appropriate product.
A bullet in the Drivers section will display all driver
packages associated with the product selection.