Avago Technologies LSI SAS 3041E-R - Manual (Page 103)

CFGGEN Commands 6-5
Version 1.3 Copyright © 2001, 2002, 2007 by LSI Logic Corporation. All rights reserved.
CFGGEN assigns two controller numbers to an LSI53C1030 dual
SCSI bus chip. It assigns one controller number to an LSI53C1020
single SCSI bus chip.
For the LSI SAS1064/1064E and SAS1068/1068E controllers the
controller # corresponds to a single SAS controller. For example, in
a system with two SAS1068 controllers, CFGGEN uses controller # 0
to reference the first controller and controller # 1 to reference the
other controller.
Valid controller number values are 0–255 (decimal).
•
The SCSI bus address of a peripheral device attached to an LSI
controller. The maximum value of SCSI ID depends on the type of
I/O controller and the maximum number of devices supported by the
OS for this controller.
Valid SCSI ID values are:
0–15 (decimal) per SCSI bus for LSI53C1020/1030 controllers
0–127 (decimal) per controller for SAS1064/1064E and
SAS1068/1068E controllers
Note: With PBSRAM, the SAS1068/1068E controllers can
support more than 128 devices.
•
The Enclosure and bay/slot of a peripheral device attached to the
bus. The argument must use a colon (:) as a separator and must
follow the enclosure:bay format. Only devices connected to LSI SAS
controllers can be addressed using enclosure:bay. Therefore, this
option is not supported on LSI53C1020/1030 controllers. Valid
numbers are:
Enclosure: A 16-bit EnclosureHandle value set by the IOC. A value
of 0 is invalid.
Bay/Slot: A 16-bit Slot value set by IOC.
The Enclosure and Slot numbers of a drive can be obtained from the
DISPLAY command.
6.3.2 AUTO Command
The AUTO command automatically creates an IM, IME, or IS volume on
an LSI1064/1064E or LSI1068/1068E controller. The volume is created
with the maximum number of disks available for use in the specified