beautypg.com

Avago Technologies LSI SAS 3041E-R User Manual

Page 63

background image

SCO OpenServer 5 Device Driver Installation

3-23

Version 1.3

Copyright © 2001, 2002, 2007 by LSI Logic Corporation. All rights reserved.

a.

Type mkdev hd at the command prompt and press Enter.

You are prompted to enter the identifier of the host adapter that
supports this disk drive.

b.

If the displayed default identifier is not

lsil

, type lsil and press

Enter.

c.

When you are prompted for the host adapter that supports the
disk drive, type the host adapter number and press Enter. (The
host adapter number appears on the screen during boot-up.)

If you are adding another LSI host adapter to the SCO UNIX
kernel, the system might prompt you to update the link-kit. If this
happens, type y and press Enter. If you entered the host adapter
number incorrectly, type n and press Enter. The system then
prompts for the host adapter identifier.

d.

When you are prompted for the bus number of the disk drive,
press Enter to accept the default (zero).

e.

When you are prompted for the target ID of the disk drive, type
the disk drive ID number and press Enter. (The target ID number
appears on the screen during boot-up.)

f.

When you are prompted for the LUN of the disk drive, type the
LUN number and press Enter, or press Enter to accept the
default value of zero.

g.

When you are prompted to update the configuration file, type y
and press Enter if the displayed values are correct. Type n if the
values are incorrect and retry from step

4.

h.

When you are prompted to create a new kernel. Type “

y

” and go

to step

13

if this is the last device to add. Type “

n

” and return to

step

10

if there are more devices to add.

11. Add a tape drive to the configuration by following the sub-steps

below. (If you are not adding a tape drive, skip to step

12.

)

a.

Type mkdev tape at the command prompt and press Enter.

b.

When the Tape Drive Configuration Program menu appears,
select option 1 to install a tape drive, and press Enter.

c.

When the Tape Drive Installation menu appears, select option 4
to install a tape drive, and press Enter.