Rockwell Automation 1503VC IntelliVAC Plus Contactor Control Module - Manual (Page 59)

4-32 Description of Features
1503-UM054C-EN-P – June 2013
This condition is valid for both Electrically Held and Mechanically
Latched contactors (TDUV and <80Vrms during hole conditions do
not apply for Mechanically Latched contactors).
I M P O R T A N T I M P O R T A N T
On a fault occurrence, of either the IB or IE
units, the contactor will be opened either by
removing power to the hold coil in an
electrically held contactor or by pulsing the trip
coil in a mechanically latched contactor.
Module Status
Figure 4.2 – Fault/Warning on IntelliVAC Plus
Table 4.F shows the Faults/Warnings conditions for the IntelliVAC
Plus module only.
IE Module/Network
Status LEDs