Rockwell Automation 1503VC IntelliVAC Plus Contactor Control Module - Manual (Page 213)

B-38 Parameters
1503-UM054C-EN-P – June 2013
Table B.8 – Consumed Network Bits
Bit Enum Text Description
0 Consumed Network Bit 0 Status of Consumed Network Bit 0
1 Consumed Network Bit 1 Status of Consumed Network Bit 1
2 Consumed Network Bit 2 Status of Consumed Network Bit 2
3 Consumed Network Bit 3 Status of Consumed Network Bit 3
4 Consumed Network Bit 4 Status of Consumed Network Bit 4
5 Consumed Network Bit 5 Status of Consumed Network Bit 5
6 Consumed Network Bit 6 Status of Consumed Network Bit 6
7 Consumed Network Bit 7 Status of Consumed Network Bit 7
8 Consumed Network Bit 8 Status of Consumed Network Bit 8
9 Consumed Network Bit 9 Status of Consumed Network Bit 9
10 Consumed Network Bit 10 Status of Consumed Network Bit 10
11 Consumed Network Bit 11/Net Start Status of Consumed Net Start
12 Consumed Network Bit 12/Net Stop Status of Consumed Net Stop
13 Consumed Network Bit 13/Net FWD Status of Consumed Net FWD
14 Consumed Network Bit 14/Net REV Status of Consumed Net REV
15 Consumed Network Bit 15/Net Jog Status of Consumed Net Jog
Contactor Network Commands [Network commands]
Parameter Number: 70,58,46,34,21.
Access rule: Get/Set
Data Type: BYTE
Object Mapping: 0xB4-1-119
Group: Control
Units: -
Minimum Value: -
Maximum Value: -
Default Value: None
This parameter allows the user to view and set the conditions of the
five (5) DeviceNet Network commands. Each bit position of the
parameter defines the state of one of the network command bits.
For each of the Network Commands listed, a status of ‘0’ indicates
that the bit is disabled and a status of ‘1’ indicates that the bit is
enabled.
Table B.9 – Network Command
Bit Enum Text Description
0 Bit 0: Start Status of Network Command Bit 0
1 Bit 1: Stop Status of Network Command Bit 1
2 Bit 2: FWD Status of Network Command Bit 2
3 Bit 3: REV Status of Network Command Bit 3
4 Bit 4: Jog Status of Network Command Bit 4