Rockwell Automation 1503VC IntelliVAC Plus Contactor Control Module - Manual (Page 300)

Parameters B-125
1503-UM054C-EN-P – June 2013
Main Coil Open on IB3 [IB 3 Main Coil Open]
Parameter Number:
240,199,158,_,_.
Access rule: Get
Data Type: USINT
Object Mapping: 0x384-3-48
Group: Diagnostics
Units: -
Minimum Value: 0 = Not Present
Maximum Value: 1 = Present
Default Value: 0
This parameter allows the user to view the status of Main Coil Open
fault from the IB3 module. If the bit is ‘0’ then the warning is not
present. If the bit is ‘1’ then the warning is present. See Open Coil
Test in Chapter 4 for a detailed description of this warning.
Main Coil Open on IB4 [IB 4 Main Coil Open]
Parameter Number:
241,200,_,_,_.
Access rule: Get
Data Type: USINT
Object Mapping: 0x384-4-48
Group: Diagnostics
Units: -
Minimum Value: 0 = Not Present
Maximum Value: 1 = Present
Default Value: 0
This parameter allows the user to view the status of Main Coil Open
fault from the IB4 module. If the bit is ‘0’ then the warning is not
present. If the bit is ‘1’ then the warning is present. See Open Coil
Test in Chapter 4 for a detailed description of this warning.
Main Coil Open on IB5 [IB 5 Main Coil Open]
Parameter Number: 242,_,_,_,_.
Access rule: Get
Data Type: USINT
Object Mapping: 0x384-5-48
Group: Diagnostics
Units: -
Minimum Value: 0 = Not Present
Maximum Value: 1 = Present
Default Value: 0
This parameter allows the user to view the status of Main Coil Open
fault from the IB5 module. If the bit is ‘0’ then the warning is not
present. If the bit is ‘1’ then the warning is present. See Open Coil
Test in Chapter 4 for a detailed description of this warning.