Rockwell Automation 1503VC IntelliVAC Plus Contactor Control Module - Manual (Page 270)

Parameters B-95
1503-UM054C-EN-P – June 2013
Contactor Drop-Out during Hold on IB4
[IB 4 Contactor Drop-out During Hold]
Parameter Number: 176,148,_,_,_.
Access rule: Get
Data Type: BOOL
Object Mapping: 0x384-4-26
Group: Diagnostics
Units: -
Minimum Value: 0 = Not Present
Maximum Value: 1 = Present
Default Value: 0
This parameter allows the user to view the status of the Contactor
Drop-Out during Hold warning from the IB4 module. If the bit is ‘0’
then the warning is not present. If the bit is ‘1’ then the warning is
present. See Contactor Drop-Out during Hold in Chapter 4 for a
detailed description of this warning.
Contactor Drop-Out during Hold on IB5
[IB 5 Contactor Drop-out During Hold]
Parameter Number: 177,_,_,_,_.
Access rule: Get
Data Type: BOOL
Object Mapping: 0x384-5-26
Group: Diagnostics
Units: -
Minimum Value: 0 = Not Present
Maximum Value: 1 = Present
Default Value: 0
This parameter allows the user to view the status of the Contactor
Drop-Out during Hold warning from the IB5 module. If the bit is ‘0’
then the warning is not present. If the bit is ‘1’ then the warning is
present. See Contactor Drop-Out during Hold in Chapter 4 for a
detailed description of this warning.