Rockwell Automation 1503VC IntelliVAC Plus Contactor Control Module - Manual (Page 129)

9-6 DeviceLogix
1503-UM054C-EN-P – June 2013
Launching the DeviceLogix Editor
After you configure the properties for the IntelliVAC Plus, you can
launch the DeviceLogix Editor. There is an additional tab in the
device properties dialog box for all DeviceLogix enabled devices.
This tab is labeled DeviceLogix. The tab provides access to the start
up window for the DeviceLogix Editor. You have the option to fill
in your name, a revision number and a description of your
configuration (all optional fields).
Figure 9.1 – Launching DeviceLogix Editor
Note:
If you are online and you click either the Parameters of the
DeviceLogix tab, you may be prompted to upload or
download the device. When you are online, the dialog
checks the configuration in the device and compares it to the
current configuration. If the configurations are not the same,
you must upload from or download to the device to make the
configurations the same before you can make changes. If
you need to make changes without uploading or downloading,
you can exit the dialog bog, go offline and re-enter the
dialog box to make the desired changes.
To start the DeviceLogix Editor for a DeviceLogix enabled device,
click “Start Logic Editor”. On the DeviceLogix Editor style