Rockwell Automation 1503VC IntelliVAC Plus Contactor Control Module - Manual (Page 154)

DeviceLogix 9-31
1503-UM054C-EN-P – June 2013
JOG
This is a dual function bit which can be used to represent the status
of a “JOG” push button. The purpose of a jog push button is to close
the contactor momentarily without having to push the stop push
button to open it. This functionality will have to be implemented in
the DeviceLogix control logic.
Protection Status
This is a dual function bit which can be used to describe the status of
any protection equipment which is connected to the inputs of the
IntelliVAC Plus.
Speed SW FWD Status
This is a dual function bit which can be used to describe the status of
the forward speed switch. These switches are commonly used on a
motor which is connected to a reversing starter.
Speed SW REV Status
This is a dual function bit which can be used to describe the status of
the reverse speed switch. These switches are commonly used on a
motor which is connected to a reversing starter.
Isolation SW Status
This is a Dual Function bit which can be used to describe the status
of the medium voltage isolation means. This may be an auxiliary
contact of the isolation switch, draw out device, or load break switch.
Remote Mode Status
This is a dual function bit which can be used to describe the status of
a selector switch which chooses between local control, and remote
control.
Local mode status
This is a dual function bit which can be used to describe the status of
a selector switch which chooses between local, and remote control.
Normal Mode Status
This is a dual function bit which can be used to describe the status of
a selector switch which chooses between normal operation mode,
and test operation mode.