Rockwell Automation 1503VC IntelliVAC Plus Contactor Control Module - Manual (Page 289)

B-114 Parameters
1503-UM054C-EN-P – June 2013
Contactor not Healthy on IB3 [IB 3 Contactor Not Healthy]
Parameter Number:
215,179,143,_,_.
Access rule: Get
Data Type: BOOL
Object Mapping: 0x384-3-56
Group: Diagnostics
Units: -
Minimum Value: 0 = Not Present
Maximum Value: 1 = Present
Default Value: 0
This parameter allows the user to view the status of the Contactor not
Healthy fault from the IB3 module. If the bit is ‘0’ then the warning
is not present. If the bit is ‘1’ then the warning is present. See Table
4.E and related description for a detailed description of this warning.
Contactor not Healthy on IB4 [IB 4 Contactor Not Healthy]
Parameter Number: 216,180,_,_,_.
Access rule: Get
Data Type: BOOL
Object Mapping: 0x384-4-56
Group: Diagnostics
Units: -
Minimum Value: 0 = Not Present
Maximum Value: 1 = Present
Default Value: 0
This parameter allows the user to view the status of the Contactor not
Healthy fault from the IB4 module. If the bit is ‘0’ then the warning
is not present. If the bit is ‘1’ then the warning is present. See Table
4.E and related description for a detailed description of this warning.
Contactor not Healthy on IB5 [IB 5 Contactor Not Healthy]
Parameter Number: 217,_,_,_,_.
Access rule: Get
Data Type: BOOL
Object Mapping: 0x384-5-56
Group: Diagnostics
Units: -
Minimum Value: 0 = Not Present
Maximum Value: 1 = Present
Default Value: 0
This parameter allows the user to view the status of the Contactor not
Healthy fault from the IB5 module. If the bit is ‘0’ then the warning
is not present. If the bit is ‘1’ then the warning is present. See Table
4.E and related description for a detailed description of this warning.