Allied Telesis AlliedView-EMS 4.0.1 DEVICE MANAGEMENT - Manual (Page 66)

Note - The Backup Address parameter is not applicable to the AT-8000S
module and should be ignored.
Static Route Table
Displays the IP static routing table.
Note - The current firmware version does not allow the Routing Type parameter to
be set to ‘local’ for all models except the AT-8000S/16. For the AT-8000S/16, the
Routing Type parameter cannot be set to ‘remote.’
IP Statistics
Displays statistics about IP routing, including the number of IP datagrams received.
Note - The current firmware version does not allow the Forwarding Status
parameter to be configured.
ARP Table Config
Displays configuration information about ARP.
I/F Name-Address Translation
Displays information about the IP interface's name translated to an IP interface
address.
TFTP
Displays configuration information about the TFTP.
Note - The current firmware version does not allow the Get Config File parameter
to be configured to receive image/config/boot files from a TFTP server.
Note - The current firmware version does not allow the Send Config File parameter
to be configured to send config/image/boot files to a TFTP server.
UDP
Listener Info
Displays UDP listener information.
UDP Statistics
Displays UDP statistics.
TCP
Connection Info
Displays TCP connection-specific information.
Note - The current firmware version does not allow the Connection Status
parameter to be configured.
TCP Statistics
Displays TCP statistics.
AlliedView™-EMS 4.0.1 Device Management Guide Page 66 of 411