Allied Telesis AlliedView-EMS 4.0.1 DEVICE MANAGEMENT - Manual (Page 245)

Port Mirroring
Displays Port Mirroring parameters and allows you to create/delete a port mirror.
Note - The Mirroring Source Module, Mirroring Source Port and Mirroring
Destination Module parameters are not applicable to the AT-9400 series and should
be ignored.
Note - L2+ Models: The current firmware version does not allow the Mirroring
Source Port (Ingress) and Mirroring Source Port (Egress) parameters to be set to
NULL.
Note - L3 Models: The current firmware version does not return any Set Error when
configuring the Mirroring Source Port (Ingress) and Mirroring Source Port (Egress)
parameters to invalid values.
MAC Address Security
Displays MAC Address Security parameters and allows you to set the security level
for dynamic and static MAC addresses learned and assigned to a port.
Note - The current firmware version does not allow the Security Mode parameter to
be configured to 'automatic', 'limited' or 'locked' when connected to an AT-9424T,
AT-9448T/SP or to an AT-9424T/PoE device models.
DoS Defense
Displays DoS Defense parameters and allows you to enable/disable a defense
mechanism on a port.
Note - The Attack Mirror Port parameter under each Attack Type option is already
obsolete and should be ignored.
Note - The Attack Mirror Port Status parameter is not applicable to the SYN Flood
and Smurf defenses and should be ignored.
LAN IP Subnet
Displays LAN IP address and subnet mask
SYN Flood Config
Displays syn flood attack type configuration
Smurf Config
Displays smurf attack type configuration.
Land Config
Displays land attack type configuration
IP Option Config
Displays IP option attack type configuration
AlliedView™-EMS 4.0.1 Device Management Guide Page 245 of 411